Honda Twins banner
1 - 3 of 3 Posts

·
Registered
Joined
·
208 Posts
Discussion Starter · #1 ·
Hey gents, been looking through steves parts cross over thread to verify if a XL250 front end will fit on a cb350 k4. I imagine it can be done, maybe with a few other parts.
So, my question is, can this be done with minimal fab work or headache?
Thanks for looking
-Dan
 

·
Sensei
Joined
·
27,183 Posts
Early XL 250 forks will fit in 450 trees on a 350 neck.....They are 35mm....350's run 33mm's stock
 

·
Registered
Joined
·
208 Posts
Discussion Starter · #3 ·
Im never ceased to be amazed at how these parts cross over. Thanks for the reply steve.
Sincerely,
-Dan from NJ
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top