Honda Twins banner

1 - 8 of 8 Posts

·
Registered
Joined
·
569 Posts
Discussion Starter #1
I cannot figure out where this spring goes. It fell out during disassembly and now I am able to get the carbs back together and working without it.. manual is no help.. Anyone know?
IMG_8224.jpg
 

·
Registered
Joined
·
79 Posts
I haven't torn into mine yet, but it looks like the spring that goes on the throttle lever stop screw. Look on Page 64 (next page) anat Figure 4-107.

Is that it?
 

·
Premium Member
Joined
·
1,638 Posts
It looks too big to be the spring on the air/fuel mixture screw on the side of each carburetor. I agree, I think it is the spring that goes into the left and right side linkage.
 

·
Registered
Joined
·
569 Posts
Discussion Starter #5
It is not the throttle lever stop screw (that is installed). It is also not air screw related (also installed). The two throttle arms butt up against each other. Middletons are you saying that this spring smooshes in between them to push them apart?
 

·
Premium Member
Joined
·
1,638 Posts

·
Registered
Joined
·
569 Posts
Discussion Starter #8
Krukster, I could see it being placed between the throttle shafts like in this sketch I just drew: Capture.JPG
 
1 - 8 of 8 Posts
Top