Honda Twins banner

1 - 9 of 9 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
When I push my starter button...or connect a starter switch..I here the starter motor spin..but its not engaging and spinning the engine...What could be wrong? will it hurt anything to still ride it by kickstart?
 

·
Registered
Joined
·
30 Posts
did this about 3 weeks ago on my 72 cl350 http://www.motorcyclesolutionsllc.com/s ... StoreFront guys name is john strawbridge call him up 419 309 2297 you will need 3 new caps, 3 new springs and 3 new rollers. you will also need a flywheel puller bolt and a tube of loctite blue. i had it apart and back together in 15 min.
 

·
Registered
Joined
·
36 Posts
Discussion Starter #5
vdubtt said:
did this about 3 weeks ago on my 72 cl350 http://www.motorcyclesolutionsllc.com/s ... StoreFront guys name is john strawbridge call him up 419 309 2297 you will need 3 new caps, 3 new springs and 3 new rollers. you will also need a flywheel puller bolt and a tube of loctite blue. i had it apart and back together in 15 min.
Thanks! I'll get on that.

Ethan
 

·
Registered
Joined
·
35 Posts
mine needed the three screws replaced. it cut them off between the clutch and flywheel.
 

·
Registered
Joined
·
56 Posts
had the same problem on my 71 cb350. Turns out the starter chain wasn't connected when I split the left side case. after reconnecting the chain, no more problems. Took me 15 mins to do (plus 1 hour to get the stripped engine screws out!) l Good luck.
 
1 - 9 of 9 Posts
Top