Honda Twins banner

1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I need some help for mounting a rear fender to the frame: The parts manual does not show this, The front of the fender sits in the rear part of the toolbox and somehow there should be a bolt through the signal light holder, through the frame into the fender, through a big opening with a rubber grommet. That hole seems awfully big. :confused: It would be nice to have a close-up picture or diagram of some sorts of what kind of hardware is used for this. Much appreciated.
Marc
 

·
Registered
Joined
·
13,085 Posts
Go to cmsnl.com, look up your bike and it will show you an exploded view of the parts (and it helps to mention the bike)
 

·
Sensei
Joined
·
27,163 Posts
I'm assuming you have a 175....... The fender mount bolt is shouldered for the large frame hole, and may (depending on which K model) have a counter-bored and tapped hole in it for the smaller mount screw.....
 

·
Registered
Joined
·
13 Posts
Discussion Starter #5
Hi Tom,
Correction here, I found a view on CSMNL that shows how it attaches. Thanks.
Marc
 
1 - 5 of 5 Posts
Top