[bobbin]

Hi everyone, I am rebuilding a k1 sl350. I got new one size over pistons that came with rings. When trying to install them today I noticed that there is no manufacturer marking on any of them. I know what order they need to be in, just don't know if there is a way to tell what side is supposed to face up. The pistons are J.C.C. pistons.

Has anyone else ran into this?

Thanks!!

 

[TOOLS1]

I have ran into this before. On the ones I had I could not even determine which way they went by looking for the bevel (there was none) so I just installed them. Never had any problems. Have over 30K miles on one of those engines now.
TOOLS

 

[bobbin]

Hey, thanks TOOLS!! I was thinking that would be my only options, good to know it worked out for you. I do see now that I posted this in wrong forum I thought I was in the 350cc section. But, I think I found out what I needed!

 

[mike in idaho]

Untitled Document

 

[nigelrharris03]

Honda manual for Rings they are from the 450 but I am certain that they apply to the 350/360 too