Honda Twins banner

1 - 10 of 10 Posts

·
Registered
Joined
·
4,400 Posts
Discussion Starter #1
I'd like to replace the lower fork oil seals and upper rubber dust seals that fit into each fork on my CB200T forks.The best(next to oem)fork seal/wiper kits I have found are K&L Supply which are Made in Japan.Do any of you know who is a vendor for these kits? fork seal dimensions are 31x43x10mm. I have looked on Ebay but so far haven't found the kit that has all 4 seals.I'd like them to be $ affordable too.
Does Common Motor Collective carry them ?
 

·
Super Moderator
Joined
·
24,208 Posts
K&L and All Balls Racing are only showing the fork seals, no dust caps. K&L #15-1428 All Balls # 55-104
Dust seal part number 51452-453-000 isn't available from Honda
DSS shows 1 "case cover" David Silver Spares USA - 51452-453-000 but I can't call it a dust seal
 

·
Registered
Joined
·
4,400 Posts
Discussion Starter #3 (Edited)
Jim,
I was looking on ebay and trying to see if the upper 'dust sea'/"oil seal" part #91254-453-000 is a similar part to other models w/ 31mm fork tubes and O.D.(45mm) that fits into the fork lower/slider and then if K&L sold that complete kit for a couple different models,but finally after an hr. and a half I rested my eyes for a while.The lower fork seals/oil seals part#91255-GAA-003 31x43x10 are available on Ebay from K&L.
I like the quality of K&L and hope this search will yield a good result.
 

·
Super Moderator
Joined
·
24,208 Posts

·
Registered
Joined
·
4,400 Posts
Discussion Starter #5
:) ok, They are the same as the 'last year'/K7 CB/CL175 models,that's good to know,now I have a couple more search options.
 

·
Registered
Joined
·
4,400 Posts
Discussion Starter #9
I wasn't able to find the upper dust seals(pt.#91254-453-000)so I ordered the lower K&L oil/fork seals from ebay last night;they are K&L #15-1428.
 

·
Registered
Joined
·
4,770 Posts
The cb175 k0-k6 seals are all 31x41x9.5 lots of people get issues with getting the wrong size (too large) the k7 and cb200's use the same triple and clamps and fork design ( bar the drum/ rotor brake. If the cb175 k7 use 31x43x10. That would explain why vendors( including Honda) get it wrong, since they assumption would be all cb175 fork seals would be the same
 
1 - 10 of 10 Posts
Top