Honda Twins banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am rebuilding a 1975 CL360, when I took apart the starter/clutch side forward handlebar control this piece fell out. Seems there are a number of chambers and cavities it could fit in. Can some identify it and tell me where it goes? If anywhere. It wouldn't be the first thing I built that had a few extra parts. Is there a thread that gives a hint on how to get these back together, with a little bit of wire it seems a tight fit.
314881
PXL_20210406_213422644 (1).jpg
 

·
Registered
Joined
·
3,051 Posts
It's the peg, normally pressed into the switch body, that fits into a hole in the handlebar to keep the assembly from turning and cutting the wires.
 
1 - 3 of 3 Posts
Top