How much blow-by is normal?

my CB400T runs great, the intake, and exhaust is stock, jeting is 2 sizes up on the primary, I have no complaints there...

when I changed the oil last week, I took the drain plug off (engine warm) I let it drain for a bit and then I gave it a few kicks to see if more oil would come out.

To my surprise, there seemed to be a lot of air blowing, it sprayed oil about 2 feet away. Also, there seemed to be more blow-by on one of the cylinders than the other.

lately it started leaking at the seam between the upper and lower case, so now I'm thinking maybe there is too much pressure in the case.

2 years ago when I got the bike, I rebuilt the top end with new rings (honed the cylinders) I used all new gaskets and torqued everything to specs, compression was good on both sides (although it took a few more kicks to reach max pressure on the RH cylinder)

i'll check compression again, but then what? head gasket? if I replace the head gasket, should I pull the cylinders off and check the rings? do I need to replace all the gaskets?...

any advice is welcome

Thanks