Honda Twins banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi All!

I am cleaning up a CB160 engine and I only have the lower half. The owner still has the upper (cylinder and head)

When we split the cases a small part fell out. In good condition, not chewed up

It looks like a very heavy duty version of an alignment dowel

It has wear on it as if it is some type of bearing.

We dry fit the cases back together and all the transmission bits are working as they should

Any advice would be great! We have been looking at the parts diagrams with no luck

20180529_161916.jpg
 

·
Registered
Joined
·
121 Posts
It looks like a transmission cam to fork roller. There may be more than one, so it may still shift, but with more strain on components.
 
1 - 2 of 2 Posts
Top