Honda Twins banner

flush mount gas cap

991 Views 4 Replies 3 Participants Last post by  danno
Has anyone done a flush mount gas cap retrofit on their bike?

I purchased one from drag specialties meant for a harley. its looks like it will work if i weld in the correct bung.. but upon further measuring i see that its going to be too tall to fit in the tank.

So i'm faced with either modifying the tank bottom and maybe the spine pf the bike. or moving the filler to a side vs being center.

OR

If someone knows of a different pop up style flush mount gas cap that would work? id be open to hearing ideas or seeing your setup

Thanks
1 - 1 of 5 Posts
I vote for moving the cap off center, I'd move it so its at the high end of the tank while on the side stand, that way you can fill the tank just a little more than before.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top