Honda Twins banner

disassembling throttle handle to replace cable

768 Views 4 Replies 3 Participants Last post by  66Sprint
CL250 1972 I've got the two screws out but the two halves of the handgrip do not seem to wish to separate. I'd like to get them apart without breaking it, and replace my throttle cable (I have a new one). What must be done to get them to let loose?
1 - 2 of 5 Posts
Did you put slack in or disconnect the cable at the carbs?....Once the screws are out, the halves should separate....
Grounding/locating pin rusted in place?...... Pry gently.....
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.