Honda Twins banner

direction of the front axles/fork tube lower pinch cap - SL350 K0/K1

980 Views 2 Replies 3 Participants Last post by  crazypj
Currently working on an 70' SL350_k0 with the 2 bolt axle pinch system under each fork tube. (33mm set up, possibly same as CL/CB of those years?) There is a thinner side and thicker side to the axle cap. My manuals are vague :eek:

When the cap is squeezing the front wheel/axle, does the thicker end of the bottom fork tube axle cap go to the rear of the fork (i.e. towards engine)? Or does the thicker side go to the side away from the motor (ie. ahead of front wheel)

The torque the front squeeze nuts before the back nuts... correct?

Thanks much!

Spoke Tire Bicycle wheel Wheel Bicycle part

Spoke Tire Wheel Auto part Rim
See less See more
1 - 1 of 3 Posts
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.