[rileyxo85]

It shorts in the inside center pin on the turn signal connectors on all the turn signals. Is this normal or do I have a short in the turn signal switch?

EDIT: I don't know if this is always the case, but I think my recently installed LED flasher relay shorted or got stuck in the on position?

 

[chaindrivecharlie]

How did you figure that out bud?
I have a new type that is load adjustable. Its for running leds, or low wattage bulbs.

https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/112783481529

 

[rileyxo85]

my bike has been shorting out. i tested all the wires in the bucket and there was a harness that was having continuity with ground so i traced it back to the turn signal switch and all three positions in the turn signal switch was grounding out.

 

[66Sprint]

The mounting stem is the ground (return) for the light...IF a good bulb is installed, it will ALWAYS show continuity from the wire to the stem.....
IF it shows continuity without a bulb installed, THEN you have a short.....

 

[TiltedGuages]

How did you figure that out bud?
I have a new type that is load adjustable. Its for running leds, or low wattage bulbs.

https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/112783481529

I went with this flasher as well.