Joined
·
3 Posts
Been working on getting a 75 CB200 running so soaked the carbs. When I pulled them of the bath out this pressed in piece (not sure what it is called) fell out. It is to loose to press back in- it just falls out.
Do I need to find a new carb body or can this piece be replaced? Is there an adhesibe that might hold it in place?
Do I need to find a new carb body or can this piece be replaced? Is there an adhesibe that might hold it in place?
Attachments
-
312.3 KB Views: 97
-
233.2 KB Views: 125