Have adjusted the clutch a few times and still cant seem to get it to work. Will take off cover and try again. Did get carbs back from Brenneys in Iowa and starts and runs fine...Hdw
Probably need more info than this - is the ball bearing still inside the riser in the clutch cover? You've got the rod with scooped end facing the cover?
Yes , took it all apart and new grease..will disassemble and try it once again..not sure I can start the bike and push rod just to see if disc are working properly...
Unusual introduction... basically, all we know is that you're someone in Bloomington who owns a CB360. Care to expound a little? And yes, pictures are a requirement around here... but welcome just the same
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Honda Twins
568K posts
36.5K members
Since 2008
A forum community dedicated to Honda Twin cylinder motorcycle owners and enthusiasts. Come join the discussion about performance, engine builds, classifieds, modifications, troubleshooting, maintenance, and more!