Honda Twins banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I am a noobie rebuilding a cb350 carburetor. Please correct any inaccuracies. There are three jets. Two main jets (a primary and a secondary) and a slow or pilot jet. The slow jet has a rubber cap. My question deals with the secondary main jet ( the one jetted at 65 or 68). I removed the jet and there is a brass jet holder underneath it. Does this jet holder come out. I have tried to push it out with a tooth pick. I broke the tooth pick off in it. I then tried other methods. The short of it is the jet holder is ruined and if the part cant be replaced I am screwed. Help Please.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.