Honda Twins banner
1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
I've been rebuilding a 1971 CL450 and my cam lobes are on the low end of the tolerance given in the Clymer manual. Is the manual accurate and if so is there any way to get decent replacement cams? Ebay has a few sets for sale but they never have any specs on them and a lot of them look like they're even more worn than mine. If I can't get replacements is there any way to get mine rebuilt?
 

·
Registered
Joined
·
47 Posts
Discussion Starter · #3 ·
Do you know the the tolerances are for warpage on the head surface are? They're not listed in the manual at all and I'm not sure if it needs milled or not.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top