Honda Twins banner

1 - 2 of 2 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
So, I just picked up an old 1980 cm200t for a friend to use to ride to the beach, & as I was poke through it I noticed something amiss:
the lower rear engine hanger bolt was missing its nut. Now, it's a 10mm bolt, but it's not the typical 10x1, so I scrounged through my old box of bicycle parts (I'm mostly a pedal-powered two-wheel kinda person, if ya know what I mean). Turns out the old Japanese nutted bottom-bracket axle nuts are exactly the same thread, & are flanged as well (with non-reversing knurling on the underside).

I know it's a slightly shorter nut, & they're typically only run down to 40lb/ft, but until I can track down the right part it's going to have to do.
 
1 - 2 of 2 Posts
Top