Honda Twins banner
1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Hey guys,

I just purchased a new rear sprocket for my 450. The description says that it will fit a 450 DOHC, specifically a K7.

I got i yesterday but I noticed there isnt a groove in it where the 4 pins seat. My old sprocket has those grooves.

How do you go about mating the pins to it? Id imagine as is, the sprocket will not line up because is pushed out further than before.

Any information is appreciated!
 
1 - 2 of 2 Posts
Top