Honda Twins banner

1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter #1
Hi,
What is the best process of removing the ignition coil on a 1968 CD175 Sloper? It"s mounted within the tubular frame below the tank.

Cheers- Pete
 

·
Registered
Joined
·
2,947 Posts
Take the fuel tank off, then unscrew two 6mm nuts and unplug two wires.
 

·
Registered
Joined
·
2,947 Posts
With the battery and air filter removed, the coil should out the right side
 

·
Registered
Joined
·
33 Posts
Just put the coil back in my '67 this afternoon. Mike is right. You'll have to remove seat and tank. Then remove the airfilter and rubber air box. If it's anything like mine, the airbox is probably pretty hard and brittle. Use some heat to soften up the rubber and then pull it back off the carb and through the rear of the frame. Then you can get your hand up inside the front of the frame to access the coil.
 
1 - 6 of 6 Posts
Top