Honda Twins banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Hi all, I have a 1976 CB360 and had a hole blown in my piston from running too lean and need some info on how to open the bottom portion of my engine that holds the rocker arms so that I can clean out any debris that may have gotten down in there (any special tools etc.). I've already purchased new pistons and had the cylinders bored for the size of the new pistons. Thank you for any info you guys can give.
 
1 - 4 of 4 Posts
Top