Honda Twins banner

1 - 1 of 1 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter #1
Hey everyone, so I have a 200T I’ve been working on, it would run fine for a few minutes and then start only running on one cylinder, I rebuilt the carbs and put acetone in the tank to melt the epoxy liner off of the inside, out everything back together and it ran fine for about 45-50 miles
Yesterday i was on my way back home and every time I went to downshift it would stall out, waited a few seconds and it’s start back up and idle again just fine, until I downshifted again, any idea on what this could be? Thanks
 
1 - 1 of 1 Posts
Top