Honda Twins banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Fuel Supply and Carburation
    Hello, I am having a little trouble setting up the Mikuni VM30s on my '78 CB400T. Any guidance would be very much appreciated! Here's the situation: The carbs came with the following parts: 6F5 needle, 159 P-5 needle jet (“emulsion tube”), AB160 main jet, and a 25 pilot jet. I have the...
  2. Fuel Supply and Carburation
    Hey all! Long time lurker, but looking for your expertise! Hopefully in the right subthread, I've never been able to figure out why the right side carb of the VM30s are making this coughing at idle to low rpms almost at stop. From cold start to a 40 mile ride it'll be fine. I can run it up...
  3. Fuel Supply and Carburation
    Hi all! I'm doing a complete carb disassembly and clean job of my VM30s. Everything was going swimmingly until I tried to remove the air jet and found it to be stuck. I tried WD-40, tapping the screwdriver with a hammer, twisting the screwdriver with a vicegrip, heat (stove, not direct...
1-3 of 3 Results
Top