Honda Twins banner
Cancel

Search Results for ‘torque settings’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

1971 1972 1974 1978 1981 1982 350 360 450 battery black bomber brake brakes brat cafe cafe racer cam chain camshaft carb carbs carburator carburetor cb160 cb175 cb200 cb200t cb250 cb350 cb360 cb360t cb400 cb400a cb400t cb450 cb450sc cb500t chain charging cl160 cl175 cl350 cl360 cl450 clutch cm185 cm185t cm200t cm400 cm400a cm400t cm450 compression custom electrical engine exhaust for sale forks fuel fuel tank gas gas tank hawk headlight help needed honda hondamatic idle ignition introduction jets jetting leak mikuni new member newbie nighthawk nighthawk 450 oil oil leak parts points project rebuild restoration scrambler seat sl350 spark speedometer starter stator suspension tank throttle timing transmission twinstar valves wiring
  1. Tires, Wheels, and Brakes
    Can someone confirm the correct torque spec for the rear axle nut on a CL72 or CL77? My Clymer manual says 142.32 ft/lbs, but this seems way too high. I have seen other references for CB's in the same year range being around 55-65 ft/lbs. I also have a couple of other service manuals for both CL...
    help please torque torque settings
  2. Manuals and Technical Documents
    Hi folks, I don't think this inconsistency in the shop manual has been identified quite as directly as this before, though I am very surprised by this as many many people must have been very confused over the years and talked about it before, and its more likely my lousy searching - in which...
    cb500t cylinder head torque settings
  3. Mechanical Issues
    Hi Im rebuilding my cb250n from the ground up and ive just had the comstars powder coated but i have no torque guide for the bolts that hold the hub the the fins. In fact i could do with a guide for the whole bike as Haynes has about three torque settings in the whole manual. cheers
    comstar torque settings
1-3 of 3 Results
Top