Honda Twins banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Project Logs
    Hello so I have dabbled with a few older Hondas but I’ve never had this problem before and I don’t know exactly what’s wrong. So I did the valve adjustment exactly how your supposed to, for the left side I had it at “LT” and I made sure it was on the compression stroke and vise versa for the...
  2. Engine Discussion
    Hey guys I recently acquired my Father-in-laws 1970 cb350 from his shed. My plans are to fully restore it to how he bought it in 1972. I have a confusing issue with cams/bore/rocker arms that I haven't found an answer for so far. He told me a couple interesting facts about his bike that has me...
  3. Engine Discussion
    Hi, I've tried looking through this forum and couldn't find anything involving this issue for my 1971 Honda CB350 regarding the valve adjustments. This bike was previously owned by a little old lady who babied it. It had low miles and is unmolested. That being said I rebuilt the carbs...
  4. Wanted Parts and Bikes
    The cam followers on my 1975 CB360T are heavily worn. Cam lobes look okay though. If anyone has 4 decent rockers laying around I would gladly rid you of them.
  5. Engine Discussion
    Hello i have a cb350 1971 and i just put in dyna electrical ignition but it wouldn't fit unless i took of the nuts for the rocker arm pin. I was wondering if its important and how much of an idiot would i be by running the bike without them? Thank you very much. I apologize in advance if this...
  6. Engine Discussion
    Hi all, I have a 1976 CB360 and had a hole blown in my piston from running too lean and need some info on how to open the bottom portion of my engine that holds the rocker arms so that I can clean out any debris that may have gotten down in there (any special tools etc.). I've already purchased...
1-6 of 6 Results