Honda Twins banner
o-ring
1-4 of 4 Results
  1. Engine Discussion
    Hiya folks! I think I'm finally narrowing down my fuel issues in my CB200. I've been fighting with it fouling out plugs lately, and I hardly get the chance to put any miles on it. I've pulled the carburetors off again (I rebuilt them the beginning of this year) to go over them again and make...
  2. Engine Discussion
    Hi there, It has been ages since I posted here, but I'm pretty stumped on something. I have oil leaks from the oil cover (major ones), crankcase cover, kickstart lever, and the cam box. I pulled the old rubber gasket from the oil cover* and replaced it with a fiber one I bought online. I was...
  3. Engine Discussion
    I've can't seem to find a clear answer on these little dowels that line up the cylinders. I have six after disassembling the engine. My question is, do any of these dowels need an o-ring to properly reassemble the engine on a 1972 CB350? This is my first post, but i've spent countless hours...
  4. Engine Discussion
    I am in the process of putting my cylinder base back on and have a question on the o-ring positioning. Is there a slight depression between the cylinder sleeve and the cylinder base that the o-ring sits slightly down into or is the base flush all the way to the sleeve? On the outside edge of...
1-4 of 4 Results
Top