Honda Twins banner

cb175

  1. Need help with my 1972 cb175

    Engine Discussion
    I cant get any ignition, I have good spark and compression so I assumed my issue was fuel. But my fuel levels are good and I have taken apart my carbs a couple times now and everything looks good, Jets are clear, floats are intact and needles are still sharp, any ideas? I have no idea what to do.
  2. n00b rider w a '72 CB175

    Member Introductions
    Hey all! I finally bit the bullet and bought a '72 CB175 last winter. It's at my dad's and this is the only pic I can find of the whole bike! :-/ I've only ridden dirtbikes a few times before, so this is my first road bike. I took the MSF Basic RiderCourse last spring in downtown BK - the...
  3. CB175 K6 "Abarth" build - Idles at red line

    Engine Discussion
    So I originally posted on the start of this build a few months back and it's damn near completion. Before I started the build I wanted to make sure the bike would run so I did a carb clean, short circuited the coils, gas in the tank and after some bowl adjustments It started up but it was...
  4. CL175 / CB175 headlight compatibility

    Electrical Discussion
    I have a new-to-me 1971 cl175 that is missing the headlight lens. Searching online parts sites I see the headlight for my cl175 is part number 33120-307-671 and is not available anywhere besides cmsnl for $$$. The same year cb175 uses headlight part number 33120-292-673 and is widely available...
  5. I think I have the wrong #14 (Needle air jet). Where to locate?

    Parts Guide
    Guys been working on this Abarth Cafe. I have it running and nearly complete but after redoing my carbs with a complete carb kit off ebay it did not come with a #3 or #14. Where do I get these? I cannot find them anywhere?! Will have photos of bike soon! -Zack MOTOZCDC
  6. New Member Introduction - Midnight Rider

    Member Introductions
    Hello Everyone Midnight Rider from Canada here! I'm not sure if I already posted a member introduction or not because it's been a while since I've been on the site. So here it is again. I'm the proud owner of a 1972 Honda CB 175 super sport that I'm super fond of. I've been shining it up for...
  7. CB175 "Abarth Cafe Tracker"

    Project Logs
    Hey guys here is the CB175 K7 project I'm calling "The Abarth 175" for the combination colors, sleek and small design. I owned a 2015 Fiat 500 Abarth black with red tand silver trim, dual exhaust, turbo 5 speed. I recently sold it. I miss it dearly. I bought it about 8 months ago not running...
  8. MotoZed - Vintage Honda Lover

    Member Introductions
    Hi guys and gals my name is Zack. I'm 33 and I live in Buffalo NY. I grew up just an hour south of the city at the southern tip of Letchworth State Park. I'm the son of a Carpenter (at least 5 generations deep) and an artist. I am a perfect blend of the two. I went to college for a long time and...
  9. Member Intro - Juan Uribe

    Member Introductions
    Hello everyone, made the mistake of jumping the gun and posting before I introduced myself; my bad. I'm in Chicago, IL. I just got a pretty sweet '73 CB175 K7. I've rebuilt a '75 Passport with my dad way back when, so I'm pretty new to servicing and repairing CBs. Have read a bunch of...
  10. Recently bought '73 cb175 k7

    Project Logs
    Hello everyone, hoping for some guidance here. I am new to the motorcycle game and came across a nice one. I can drive a motorcycle, but don't have too much experience. Also don't have much experience working on bikes, but I've worked on a 75 Passport before. The battery was making contact with...
  11. Introduction - CB175 Cafe Racer Build On The Way !

    Member Introductions
    Hello, I’m a new member and have always wanted to build a cafe racer. I have little to no experience in motorcycles, only cars. However I have been researching Cafe Racers for the past few years and came across a sweet deal for this beauty CB175. Any tips or advice for starting off my new build...
  12. CB175 Timing Chain Broken / Engine Disassembly

    Engine Discussion
    Hi! A while back, I was riding along on my 1970 CB175 at about 50mph and my engine stopped working all of a sudden. I killed the ignition immediately and towed it home. Turns out my timing chain broke due to it being too loose. I tore the engine apart and bought a new chain, but now I'm...
  13. Carrying On Family Tradition

    Member Introductions
    Hello everyone, I am from California and I have just started my first project resurrecting a dirtbike that belonged to my grandpa. The engine in the bike is a CB175 and the other components including the frame and exhaust are a custom mashup. My grandpa and his dad (Whitey Tompkins) and uncle...
  14. CL 160 175 sloper head identification

    Engine Discussion
    Hi Guys! its been a while since Ive been here. My cl 160 had some motor problems last year in april and I brought it into a shop, its still there!!! The valves were pretty much wrecked so I bought another head, the guy who sold it to me says it was a 160 head. It bolts on and looks almost...
  15. New Member from Fayetteville, Arkansas.

    Member Introductions
    Hi all! Long time lurker and new member here. My name is Kat. I'm 28 years old and I live in Fayetteville, Arkansas. I'm a freelance graphic designer, illustrator, web designer, and front end web developer. I was introduced to the world of vintage motorcycles about six years ago now, and it's...
  16. FS: Cylinder head for vertical 175cc twin

    Parts For Sale
    Listers, I have a good cylinder head for a vertical 175cc engine. CB, CL etc...... No camshaft, missing 1 exhaust valve. Other valves, springs, and rocker arms included. $50 plus shipping. Contact me off list if interested. [email protected]
  17. '72 CB175 reassembly questions

    Engine Discussion
    This is my first motorcycle engine rebuild and I'm being as cautious as my mind will allow. I've got several questions and I apologize but I didn't want to make eleventeen different threads. 1. Is it worth upgrading the charging system with an CB200 generator? I will be upgrading to the...
  18. WTB Keihin 160 carb jets

    Wanted Parts and Bikes
    Hello Listers, I am looking for a pair of 160 size carb jets to fit my 1968 CL175KO. Many thanks. Michael Mpls
  19. CL175 -- no light when timing ignition

    Electrical Discussion
    I have a CL175 that I've been slowly restoring (not beautifying, but getting to running condition): https://www.hondatwins.net/forums/40-engine-discussion/117870-oil-leaking-clutch-pushrod-seal.html I have everything back on the bike, and now, going to set ignition timing with a test light, I'm...
  20. Restoring a 72 CB175

    Member Introductions
    Hi all, My winter project this year is to rebuild the 72 CB175 I recently picked up. It runs, but that's about all it does. I'm trying to learn all I can now before actually diving in. I'm building a small one bike workshop in my yard now. Looking forward to chatting with and learning from all...
Top