Honda Twins banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Fuel Supply and Carburation
    Hello, I am having a little trouble setting up the Mikuni VM30s on my '78 CB400T. Any guidance would be very much appreciated! Here's the situation: The carbs came with the following parts: 6F5 needle, 159 P-5 needle jet (“emulsion tube”), AB160 main jet, and a 25 pilot jet. I have the...
  2. Member Introductions
    Hey I’m a new member, just pulled my fathers old bike out of a field after it sat for about 13 years. Carburetors fought me and many things stripped, so now looking for either a complete replacement set or a singular replacement. I have a 1978 Honda hawk 400 and need the carburetor that has the...
  3. Fuel Supply and Carburation
    Hi everyone, I'm new to here. I just got confused with my Honda Rebel 250 performance. It has 65k km. First I noticed that both intake manifolds backfire occur in idle. And right exhaust pipe emitting black smoke but left is ok. I remove plugs and checked. Right plug is blacked where I identify...
  4. Fuel Supply and Carburation
    I just tried firing up my 1980 cm400t after tearing down the top end to the connecting rods to fix a head gasket leak and putting it all back together again. My first time with a job like this. I also had a leak from the carburetor cross-over tube, so while I was taking things apart I pulled the...
  5. Fuel Supply and Carburation
    Hey guys, I recently picked up a '71 CB350 and am in the baby stages of doing some overhaul on it. For the most part, it runs well, kicks over every time and rides relatively smoothly. I've noticed 2 problem areas and was hoping to get some input: 1) One of my exhausts is running hotter...
  6. Fuel Supply and Carburation
    Hello all, I am hoping someone could help me figure this out. I recently bought my first bike, a (non-running) 1983 CB450sc. Immediately I removed the tank, changed the oil and plugs, and rebuilt the carbs (in which I replaced the main and slow jets, gaskets, etc) . When I first tried to fire...
  7. Fuel Supply and Carburation
    I recently purchased a CL350 which was not in great running order. I lucked out however and after changing out the throttle cable, adjusting the carbs and putting some new oil in it, she runs like a dream. However my right carb is missing the drainage valve/screw (I'm not sure what you call it)...
1-7 of 7 Results
Top