Honda Twins banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Engine Discussion
    This page specifies a cylinder surface finish of 1s to 1.5s. Does anyone know what “s” is supposed to mean or how to convert it to something an amerimut can understand?
  2. Wanted Parts and Bikes
    Hi all! This is my first post here in the Hondatwins community, so bear with me... I am looking for a new set of cylinder jugs for my 1972 CB450 rebuild. I took them to a local vintage motorcycle rebuild business here in Ferndale, Michigan. There was some cylinder wall damage on the left...
  3. Engine Discussion
    I am looking for a set of pistons to go in my CB360, which is in need of being bored out. Any ideas on how well these pistons for a Yamaha xt225 might work in the cb360? They have a bore size of 70mm and the wrist pins have a diameter of 16mm. However, they are shorter in height. In theory...
  4. Engine Discussion
    I'm a new member and have started a few cb projects. Currently, I have (2) cb350, and (1) cb100 engine torn down. One of the 350's is a K0, the other is a K4. I'm at the point of all of these where I need to make a decision what needs to take place with the pistons, rings, and cylinder walls...
  5. Engine Discussion
    Hey everyone! I'm taking the cylinders, head, and pistons/rings from my '78 CB400t to a machine shop to get them checked out before I rebuild the engine. I have the Clymer manual, but I want to make 100% sure that the specs listed in it are accurate. We all know how Cylmers can be...:rolleyes...
  6. Engine Discussion
    Continuing on with my CB 350 project. Engine teardown is in progress. The top end is more or less in pieces and its time to decide what to do with the jugs. I had the great fortune to have the cylinders measured up by our very helpful QC guy and his faro arm after work today. Both are right on...
1-6 of 6 Results