View Profile: amannl - HondaTwins Forums
Tab Content
  • amannl's Avatar
    07-14-2019, 09:03 AM
    I did ultrasonically clean the carbs so I’ll spray the spray the felts when I get a chance later today. and Tom, I did let the bike idle for several...
    4 replies | 77 view(s)
  • amannl's Avatar
    07-13-2019, 02:39 PM
    This has been a long rebuild; several years since a crank main disintegrated. Today I finally got the battery charged and gas in the tank and it...
    4 replies | 77 view(s)
  • amannl's Avatar
    07-09-2019, 05:35 AM
    Both, Thanks for clarifying about what should match. and yes, I’m aware of the different size diameter of the pivots of the denso and hitachi points....
    3 replies | 88 view(s)
  • amannl's Avatar
    07-08-2019, 03:10 PM
    Ive read that the AAU and points plates should match (by manufacturer), so could someone identify the logo on my advance unit? Denso, Hitachi, etc?...
    3 replies | 88 view(s)
  • amannl's Avatar
    07-08-2019, 03:06 PM
    amannl replied to a thread CB160 Compression in Engine Discussion
    I’m going to keep on riding, until and/or if it gets worse. But I have a small shed, not a garage, so if I decide to do it it can’t wait until...
    18 replies | 314 view(s)
  • amannl's Avatar
    07-06-2019, 09:17 AM
    amannl replied to a thread CB160 Compression in Engine Discussion
    Tools, the temps of the exhausts, an inch or so below the clamp, were ~173-175 on the left and 181-183 on the right. what do, or what would temp...
    18 replies | 314 view(s)
  • amannl's Avatar
    07-06-2019, 07:38 AM
    amannl replied to a thread CB160 Compression in Engine Discussion
    Thanks all. I’m going to go for a ride this morning and will check header temp when I get back as I bought an inexpensive infrared thermometer a...
    18 replies | 314 view(s)
  • amannl's Avatar
    07-05-2019, 01:51 PM
    amannl replied to a thread CB160 Compression in Engine Discussion
    I think I just figured it out. I just came back from starting the bike to go for a ride just now and a small cloud of smoke (from the oil I added to...
    18 replies | 314 view(s)
  • amannl's Avatar
    07-05-2019, 12:13 PM
    Will someone confirm what the actual compression limits are for a CB160? The Honda Shop manual lists compression as 141.9 psi and service limits...
    18 replies | 314 view(s)
  • amannl's Avatar
    06-25-2019, 08:33 AM
    Steve, I saw your post when I searched the topic, as well as the sticky “CB175 headlight retrofit. thanks again, Adam
    2 replies | 66 view(s)
  • amannl's Avatar
    06-24-2019, 01:20 PM
    Can someone tell me what the diameter of the Cl125 (center code 243) headlight bulb is? Id like to swap a non-sealed reflector into my CB160 shell...
    2 replies | 66 view(s)
No More Results
About amannl

Basic Information

About amannl
Location:
NYC & upstate NY

Statistics


Total Posts
Total Posts
98
Posts Per Day
0.03
General Information
Last Activity
Today 06:13 AM
Join Date
06-15-2009
Referrals
0